1. Model: ADL0842-PB20P03531 
 2. Input voltage and frequency 

 Frequency voltage frequency range voltage range 
 170-240VAC 160-264VAC 50-60Hz 47Hz to 63Hz 

 3. Input Current: 

 From zero load to full load, when operating in 170-240VAC, AC input current shall not exceed 0.6A 

 4. Inrush current 
 Work at 240VAC, the inrush current is limited to 50A. Inrush current measurement is the ambient temperature is 25 ℃, tested unit to power off until the temperature stability of the measured ambient temperature. 

 5. Output characteristics 

 In any line and load changes and various environmental conditions, the output should be consistent with the range of data shown in Table 1 

 Nominal input voltage 170-240VAC 
 Maximum output power (W) 93 
 Output Number 7 
 84 * 1W LED Quantity 
 Each output current (A 0.35 ± 5% 
 Power factor ≥ 0.95 
 Minimum load (A) 0.0 
 Maximum output voltage 112VDC ± 5% 

 6. Input current protection 
 The input side of a 2A fuse should be installed to provide protection against power. 

 Ripple measured at least use the oscilloscope bandwidth limitations when the output to a ceramic capacitor in parallel and an electrolytic capacitor to simulate the temperature of the system load 



 8.LED connection 



 LED Qty: 28 * 3 = 84 

 9. Output cable polarity 
 The power supply with 9 LED dimming and inspection functions. 

 10. Over Power Protection 
 The power supply should be able to burst over the output power (greater than 110W), the damage will not be protected, the lifting of automatic recovery when the fault. 

 11. Output cable pole 

 Color output polarity 
 Red * 3 LED1 +, LED2 + LED3 + 
 Black * 3 LED1-, LED2-LED3- 

 12. Environmental requirements 

 12.1.1 Operating temperature and humidity range: 
 All operations should be consistent with the temperature 0 ℃ to 50 ℃, relative humidity 20% to 90% range. 
 12.1.2 Storage temperature and humidity range 
 Storage or transport temperature should be -20 to 70 ℃, relative humidity of 20% to 90% range. 
 12.2.3 Altitude 
 The LED drive power should be in the altitude range from 0 to 10,000 feet, 40,000 feet in operation and stored in the following. 
 13. Safety standards 
 Product Safety Standards 
 In addition to the special specified, the power supply designed to meet EN61347 and / or equivalent safe use of information technology equipment standards. And bear the associated costs to customer requirements, the certification will apply for specific institutions. 
 13.1.1 Leakage current 
 When the LED drive power received 240